Payment & Shipping Terms:
|Material:||Metal||Hose Length:||50 Ft./15m|
|Hose Included:||No||Hose I.D:||1/2 In(13mm)|
|Hose O.D:||7/8 In( 22mm)||Drive Type:||Spring|
|Max Pressure:||500 Psi/35 Bar|
Series 7000 is now available as a safe and efficient respitory
component. It features strength and reliability as with every other Series
7000, and in addition the fluid path is non-corrosive stainless steel.
Reelcraft’s 7800 OLB21 clean air reel is designed to reduce the operator’s
burden of managing long lengths of hose. When the reel is not in use,
expensive respitory hoses are stored up and out of harms way. The reel
holds 50’ of 1/2” I.D. neoprene hose.
Be sure reel base is securely grounded to mounting surface. Check for continuity following installation. On painted surfaces, remove paint at bolt location, use external tooth lockwashers or run ground wire from reel base to grounded object. Failure to ground will prevent reel from performing its intended function and could result in personal injury.
Mount reel to grounded, metal surface using four holes in mounting base. To minimize wear on cable and cable guide, reel should be
mounted in direct line with work so that cable is pulled out as straight as possible during use. See figures 1 & 2.
If you have any questions, please contact us without any hesitation.
|Packaging Details:||Standard Export carton Package|
|Delivery Details:||Delivery time for Sample: 3 days / Delivery time for Order depends on quantity
Shipping:BY DHL, FedEx, UPS or TNT......
Adding wraps of hose will increase spring tension. This can be accomplished by pulling out approximately 10 feet of hose, hand feed hose back up through roller bracket assembly* until loop is large enough to slip over sheave. Add two or three wraps until desired tension is achieved. Do not exceed spring capacity.
This can be accomplished by removing wraps of hose from the reel sheave. Remove wraps of hose from the sheave, one wrap at a time, until desired tension is obtained.
*For Series D9000 reels, you will have to remove the bumper and control handle then feed end of hose through roller bracket assembly to add or remove wraps of hose from the reel drum.
Retractable Electric Spring Driven Cord Reel with 45-Feet of 12/3 Cord and GFCI Dual Outlet Cable Reel
2.How do I install a new drive spring and set pre-turns?
We have several different types of spring driven reels. Each require a slightly different set of instructions. For "How-To" instructions on replacing a drive spring please have your reel model or drive spring number available and consult customer service for instructions.
For how many wraps of "pre-tension" to put on the reel, please reference the chart below.
|Spring Number||Wraps Required|
3.Can my spring driven reel be made "constant tension"?
While most JARCH spring retractable reels can be made "constant tension" at the factory or by simply removing the latching system there are some models that may not have this capability.
Please contact Reelcraft Customer Service to assure that the specific reel you have or require is capable of or available as a "constant tension" model.
4.Reel will not latch
This could mean it has a broken latch spring, bent latch pawl or latch plate. The broken part(s) will need to be replace.
Contact Person: Kris