Instruction for installation of rotational connection
April 6, 2021
Instruction for installation of rotational connection(旋转接头安装说明）:
- Clean an installation site.
The diameter of a spindle and surface have to be without damages.
- Connect a flexible hose on "the Entrance 1", "the Entrance 2" and "Drainage", but before connection condenses a carving with Teflon (the flexible hose has to be connected before installation of connection on a spindle, otherwise connection can be damaged).
- Connect flanges of rotational connection with the counter flange by car No. 6 the M12x25 Screw.
General information for connection installation（连接安装基本信息）:
For the correct work we advise to arrive as follows:
Check that the system would be properly cleaned and did not contain rigid particles.
Make sure of the existing system that the quality of the filter and functionality are according to the requirements of a hydraulic system.
Do not use rigid supplies from pipes.
Establish a rotational connection to the car.
Connect a flexible hose to hydraulic lines.
Check that connection is not established strictly.
When using metal flexible hoses in a short place with small radiuses, use only 45º or 90º a knee to avoid excess tension.
Check that connection is reliably fixed and there is no side play.
Examine connection periodically in time to find the leak.
The firm is not responsible for any damages which arose because of misuse of connections or parts.
The use of connections in mixed liquid and gases is dangerous since flammable, corrosion, toxic or explosives, are forbidden.